Hot!My newbie propane problems...

Page: < 12 Showing page 2 of 2
Author
410John
Hamburger
  • Total Posts : 100
  • Joined: 2017/07/06 14:15:50
  • Status: offline
Re: My newbie propane problems... 2018/02/15 13:43:28 (permalink)
Thanh you. Check us out on Face Book there's a story and more pics. "410 Empanadas"
#31
BiggE
Hamburger
  • Total Posts : 82
  • Joined: 2015/03/01 00:20:00
  • Location: Tallahassee, FL
  • Status: offline
Re: My newbie propane problems... 2018/04/18 10:09:12 (permalink)
410John
Installed the two stage and all works well!



410John, Did you install your 2 stage regulator along with your supplied appliance regulator?  I ask because I have a 2 stage regulator set up as well but my new range was delivered with a regulator attached and I was thinking that I wouldn't need that one since my lines are at 11 WC already.  If anyone could chime in and give me some input I would greatly appreciate it.
#32
edwmax
Double Chili Cheeseburger
  • Total Posts : 2412
  • Joined: 2007/01/01 15:42:00
  • Location: Cairo, GA
  • Status: offline
Re: My newbie propane problems... 2018/04/18 22:11:40 (permalink)
Check your appliance installation manual.    Some of the appliance regulators steps the pressure down again from line pressure (11" WC or higher); and some only work as an steady/excess flow control for even supply flow.   The manual should state  what is needed at the appliance regulator.
post edited by edwmax - 2018/04/18 22:15:02
#33
BiggE
Hamburger
  • Total Posts : 82
  • Joined: 2015/03/01 00:20:00
  • Location: Tallahassee, FL
  • Status: offline
Re: My newbie propane problems... 2018/04/23 13:09:46 (permalink)
edwmax
Check your appliance installation manual.    Some of the appliance regulators steps the pressure down again from line pressure (11" WC or higher); and some only work as an steady/excess flow control for even supply flow.   The manual should state  what is needed at the appliance regulator.


Thanks edwmax.  I'll leave it attached to the appliance.  If the gas flow is hindered in any way I know just where to start.
#34
Page: < 12 Showing page 2 of 2
Jump to:
© 2018 APG vNext Commercial Version 5.5